WE HAVE SOME GREAT LIMITED-TIME OFFERS - CLICK HERE TO VIEW THEM WE SHIP WORLDWIDE    /    All UK ORDERS GREATER THAN £75 EX VAT DELIVERED FREE    /    WE SHIP WORLDWIDE    /    ALL EUROPEAN ORDERS GREATER THAN £500.00 ex VAT DELIVERED FREE    /    WE SHIP WORLDWIDE
    Share this page on Facebook   Share this page on LinkedIn   Share this page on Twitter   Share this page on Whatsapp   

    Rapid Ref : CK-CK20FX  Mfr Ref : CK20 FX

    CK20 Flexi Torch Head 250 Amp
    CK20 FX CK-CK20FX

    £75.87  EX VAT
    SSP Suggested Selling Price = £151.73  YOU SAVE £75.87
     Buy in 3 easy interest free payments of £25.29† with

    CK20 Torch Parts FAQs

    Torch bodies, handles, back caps and cable and hose sets for a water-cooled TIG torch: how to pick the right part and look after it.

    When is a water-cooled torch a better choice than an air-cooled one?icon-minus-redicon-plus-red

    Air-cooled torches can overheat during long welding runs, and the usual answer is either to let them cool or to move to a water-cooled torch. Water-cooled torches are therefore generally chosen for sustained higher-current work and long arc-on times.

    Air-cooled torches are lighter and simpler because they need no cooler. A water-cooled torch needs a suitable cooler connected to the machine and the hoses kept in good order. The current at which people switch varies between makers and sources, so look at the rated current and duty cycle in your torch manual rather than relying on a rule of thumb.

    How do I know coolant is actually flowing through the torch?icon-minus-redicon-plus-red

    Do not judge flow by feel. Some makers' manuals say to make sure the coolant is circulating correctly while you weld, and with their own coolers this can be seen as a steady return flow in the cooler's tank. Many coolers also have a flow switch or warning light, so check what yours has.

    If the return flow stops, the handle gets hot or the cooler alarms, stop welding and find the cause: a low level, a kinked hose, a blocked line or a cooler fault. Running the torch without flow can quickly damage the power cable and the head, so check flow every time you start work.

    What coolant should I use and what should I avoid?icon-minus-redicon-plus-red

    Use the coolant recommended by the makers of your torch and cooler. A water-cooled torch must never be put into service without coolant, so check the level before every session.

    Plain tap water is generally advised against: it conducts electricity, so current passing through the circuit can cause corrosion that releases particles and blocks the narrow passages, scale can build up, and it can freeze in cold conditions. Ordinary car antifreeze should only be used if the manuals say it is suitable, because additives vary. A purpose-made, low-conductivity welding coolant is the usual choice. Do not mix liquids unless the manual says you can, and follow the cooler manual for how often to test or change the coolant.

    What should I do when I disconnect the hoses from the cooler?icon-minus-redicon-plus-red

    Switch off and isolate the machine and the cooler first, and let the torch and coolant cool down, as some coolant stays in the torch body and can be hot after welding.

    Some torch manuals tell you to seal the coolant hoses with the plastic stoppers supplied whenever they are detached, which stops coolant escaping onto the floor or electrical parts. Keep coolant away from the machine and from live connections, and wipe up spills at once. When you reconnect, match the connectors by their markings or colours, tighten them correctly and check for weeping before you start welding.

    Shop Similar Categories